Brush-on Ceramic 2lb Kit

ML406 Brush-on Ceramic is a two component, brushable, 100% solids(solvent free) high technology polymer formula, combined with diamond-hard ceramic fillers that provide an exceptionally tough surface for wear and corrosion areas.  It offers a high gloss surface to eliminate sticking and turbulence.  In addition to withstanding fine particle abrasive attack, it also protects against moderate corrosion, andwithstands temperatures up to   400ºF.  Each ML406 kit contains two colors, (red and blue), so that by alternating layers, you can more easily gauge wear.
ML406-2 - 2# Kit (Includes: 2ea 1# Containers, 1ea Red, 1ea Blue)

TYPICAL APPLICATIONS:   

• Tube Sheets   
• Water Boxes   
• Pump Housings   
• Impellers   
• Tank Linings   
• Cyclones   
• Cort Nozzles   
• Chutes, Pipes, & Elbows   
• Hydroturbine Housings   
• Discharge Nozzles   
• Mixing Blades

TECHNICAL DATA:
Compressive Strength (ASTM-D-695-54)......................................................................21,000 psi
Tensile Strength (ASTM - D-638)...................................................................................4,800 psi
Operating Temperature (constant).....................................................................................250ºF
Intermittent Temperature Fluctuations.......................................................................up to 400ºF
Dielectric Strength..........................................................///.500 volts/1 mil thickness (25 microns)
Hardness (Shore D)...........................................................................................................96 D
Working Time (Pot Life) @ 77ºF..................................................................................25 minutes
Cure Time @ 77ºF..........................................................................................................6 hours
Coverage................................................................................3 sq. ft. per pound @ 30 mils thick
Mix  Ratio  -by Volume..................................................................................6 parts B to 1 Part A                                -by Weight.................................................................................14 parts B to 1 Part A

APPLICATION INSTRUCTIONS:
1.  Grind, sand, brush or grit-blast surface for best adhesion.  Clean with (74156) MM Safety Solvent IVDegreaser and wipe dry.  In humid climates it is advisable to flame brush the surface to prevent flashrusting and to help the polymer to "wet out".  Apply MM Silicone Spray (74108) as a release agent toany area you do not want the compound to adhere to.

2.  Mix all Resin and all of Hardener thoroughly until uniform in color (no streaks).  Apply fully mixedmaterial to desired surface with the enclosed brush.

3.  Working time is 25 minutes at room temperature.  Material is hard in 6 hours and fully cures in 12hours.    The curing time may be shortened considerably by heating the surface to 150 degrees F.Second coats may be applied as soon as the first coat is firm (usually about 45 minutes)